Instructions Verified | Dt6507 Led Mirror Clock

If you cannot find this option, try pressing (or a hidden combination: SET + UP simultaneously for 3 seconds).

Check if your clock is set to the wrong 12/24-hour cycle or if Night Mode configurations are conflicting with manual adjustments. Re-run the setup steps outlined in Section 2.

When the alarm sounds, press any button except the button to activate snooze. The alarm will sound again after the designated snooze interval. To turn the alarm off completely for the day, press the MODE button. 4. Brightness Adjustment and Night Mode (CDS)

Press once to confirm. The hour digits will begin to flash. dt6507 led mirror clock instructions

Press the button twice to display the current room temperature. While the temperature is on the screen, press the UP button to toggle between Celsius ( °C ) and Fahrenheit ( °F ). 🔧 Troubleshooting and FAQs

Press and hold the MODE button for about 3 seconds until the display begins to flash.

: Switches between display modes (Time, Date, Temperature, Night Mode) and enters settings. If you cannot find this option, try pressing

How do I stop the clock from switching between time, date, and temperature?

The will flash. This represents the number of minutes the snooze lasts. Use UP or DOWN to adjust (default is 5 minutes). Press ALARM to save.

The DT6507 has a straightforward, LED-based interface. Press the MODE button to cycle through its three main display screens: When the alarm sounds, press any button except

: Press any button except SNZ/LIGHT to turn the alarm off for the rest of the day. 5. Temperature and Brightness Settings Temperature Scale Toggle

An (usually a small bell or dot) will appear on the screen when the alarm is active. Handling a Ringing Alarm

The digits will flash. Use UP/DOWN to adjust, then press MODE to finish. 2. Setting the Alarm Short press ALARM to see the current alarm time.