V2000-c Rfid Access Control User Manual ((free)) Jun 2026

Symptom: Keypad keeps buzzing, and the red light is flashing quickly.

The Master Code is now restored to factory default ( 999999 or 123456 ), while user data remains intact. 6. Troubleshooting and Indicator Statuses LED and Sound Indicator Key LED Color / Sound Action / Status Access Granted Relay is activated; door is unlocked. Red LED Slow Flash Standby Mode System is armed and working normally. Yellow LED Solid Programming Mode Device is open for configuration changes. 3 Short Beeps Error / Invalid Input

Complete User Manual and Configuration Guide for the V2000-C RFID Access Control System

A common frustration with new access control installs is the "door didn't open" issue. Usually, this isn't a broken lock, but a timing issue.

You can customize how the lock behaves when valid access is granted. Access Modes (How Users Unlock the Door) : Press 3 ➔ Press 0 ➔ Press # . Card OR PIN (Default) : Press 3 ➔ Press 1 ➔ Press # . Card + PIN Combined : Press 3 ➔ Press 2 ➔ Press # . Adjusting Relay Strike Time V2000-c Rfid Access Control User Manual

A: Yes. Any Wiegand 26/34 output device can connect to terminals 10(+), 11(D0), 12(D1), and GND. The V2000-c will treat the fingerprint ID as a card ID.

Use the rear plate of the enclosure as a template to mark drill locations for the wall anchors.

If the Master Code is lost, reset the device manually using the hardware pins. Power off the V2000-C unit completely.

The V2000-c supports three operational modes. Switch using [Master Code] + # + 19 [Mode] # . Symptom: Keypad keeps buzzing, and the red light

Once the system is installed and programmed, it is ready for daily use. Here is a summary of how different components behave during normal operation.

Since "V2000-C" is a popular model produced by various access control manufacturers (most notably by or as a generic OEM model sold under brands like Generic/Vision), the exact manual layout can vary slightly. However, the functionality is almost identical across these devices.

Press 0 + New Master Code + # + Confirm New Master Code + # . Note: The Master Code must be 6 digits long. Set Access Mode (Entry Options) You can choose how users gain entry to the building: Press 1 + 0 + # Card OR PIN (Default): Press 1 + 1 + # Card + PIN Combination: Press 1 + 2 + # Set Relay Strike (Unlock) Time Enter Programming Mode.

To configure the relay, adjust the jumper on J1. The behaviour also depends on how the COM (J3) terminal is configured: 3 Short Beeps Error / Invalid Input Complete

Incorrect PIN, unregistered card, or programming syntax error. Alarm Triggered Tamper sensor activated or door forced open. Common Troubleshooting Scenarios

This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.

Connect the wire of the V2000-C directly to the Positive (+) terminal of the Electric Strike. 3. Programming and Configuration Guide